Shanghai Sunland Industrial Co., Ltd is the top manufacturer of Personal Protect Equipment in China, with 20 years’experience. We are the Chinese government appointed manufacturer for government power,personal protection equipment , medical instruments,construction industry, etc. All the products get the CE, ANSI and related Industry Certificates. All our safety helmets use the top-quality raw material without any recycling material.
Emergency plan for wearing safety helmet on construction site
We provide exclusive customization of the products logo, using advanced printing technology and technology, not suitable for fading, solid and firm, scratch-proof and anti-smashing, and suitable for various scenes such as construction, mining, warehouse, inspection, etc. Our goal is to satisfy your needs. Demand, do your best.
Professional team work and production line which can make nice quality in short time.
Address：No. 3888, Hutai Road, Baoshan District, Shanghai, China
27/5/2008, · As long as it's on top of the top coat of lacquer, and is actually a sticker, sure. Just take it off as you would any bumper sticker. Hairdryer/heat gun, peel, and then use Goo Gone to remove the residue. Some manufacturers (I've noticed it a lot with HJC) are actually making the logo on the back of the helmet part of the design.
"After riding, the best thing to do is to not put your helmet in a bag or box," Tabitha Knaub says particularly if it's fabric-lined. Instead, she advises, wipe the inside with a clean, damp cloth; then let the helmet air-dry. If you must, go ahead and store your helmet in your tack trunk or a hat bag, but only temporarily.
Remove a snap-on shield by holding the frame firmly. Open the right temple and grasp the side shield. Gently bend the side shield toward you from the top and then the bottom, with a firm, wiggling motion. The side shield should come off. If it doesn't, slide it slightly down the temple away from the frame and repeat with the bending and wiggling.
Helmet Removal, Steps in ,removing helmet,: ,Helmet removal, may follow facemask ,removal, unless primary assessment dictates that emergency care be administered prior to facemask ,removal,. The patient must be in a supine position with C-spine in neutral alignment. The shoulder pads should be prepped for access to the chest before ,removing, the ,helmet,;
Gently but with pressure slide the safety shield down the temple to the end. For snap-on shields, wiggle the top and bottom of the shield as you slide it down the temple until it loosens. Do not remove side shields that are held in place permanently with a clip, bolt or pin.
Lower the inner shield by pushing the slider button located on the left hand side of the helmet completely forward. With the inner shield in the down position, grasp and pull straight out from the helmets eye port on each side of the inner shield to remove. You will feel the inner shield unsnap from the helmet.
Remove any helmet that is exposed to direct flame. Carefully examine fiberglass helmets exposed to high heat for potential surface cracking/crazing due to the exposure. The fiberglass shell should remain rigid when you attempt to flex the material. Any cracking sounds and ease of …
Inflating the bladder lifts the helmet off of the head with little to no neck movement thereby reducing the risk of complications from helmet removal. Action Sports EMS has been using the Eject Helmet Removal System since 2010 and its use is explained at all of our rider safety meetings.
Other ,helmets, are designed to protect against multiple moderate impacts, including football and hockey ,helmets,. However, you may still have to replace these ,helmets, after one severe impact, particularly if the ,helmet, has visible signs of damage, such as a cracked shell or a permanent dent. 5. A ,helmet, is just part of ,the safety, equation.